Eclipse Community Forums
Forum Search:

Search      Help    Register    Login    Home
Home » Eclipse Projects » Hudson » Initial Installation Enable Security Problem
Initial Installation Enable Security Problem [message #864012] Sun, 29 April 2012 15:44 Go to next message
Ian Selfe is currently offline Ian Selfe
Messages: 2
Registered: April 2012
Junior Member
After installing Hudson 2.2 using Tomcat 6.0.35 I am able to access the UI successfully. I am trying to secure Hudson using the Standard Security Setup page in the current documentation. ( unable to link because I haven't posted more than 25 messages )

When i try to log in as the first user, I am taken to a HTTP 404 page.

I have disabled security by editing my config.xml and ran through the steps for Standard Security Setup again, yet I still run into the 404 when I try to log in.

Any suggestions? Has anybody ran into this problem before?
Re: Initial Installation Enable Security Problem [message #867923 is a reply to message #864012] Tue, 01 May 2012 10:57 Go to previous messageGo to next message
Winston Prakash is currently offline Winston Prakash
Messages: 405
Registered: August 2011
Location: Fremont, CA USA
Senior Member
What Authentication and authorization you setup? Did you remove both
authorization and Authentication elements in the config.xml file.

Did you look at the Tomcat log file to see what kind of exception is
reported?

- Winston

On 4/29/12 12:44 PM, Ian Selfe wrote:
> After installing Hudson 2.2 using Tomcat 6.0.35 I am able to access the
> UI successfully. I am trying to secure Hudson using the Standard
> Security Setup page in the current documentation. ( unable to link
> because I haven't posted more than 25 messages )
> When i try to log in as the first user, I am taken to a HTTP 404 page.
> I have disabled security by editing my config.xml and ran through the
> steps for Standard Security Setup again, yet I still run into the 404
> when I try to log in.
>
> Any suggestions? Has anybody ran into this problem before?


Winston Prakash
Eclipse Hudson team
Re: Initial Installation Enable Security Problem [message #867977 is a reply to message #867923] Tue, 01 May 2012 11:26 Go to previous message
Ian Selfe is currently offline Ian Selfe
Messages: 2
Registered: April 2012
Junior Member
I used
- Hudson's own user database
- Matrix-based security

I allowed anon to read all then created a user "setup" as the first user. I then created that user and attempted to login.
Unfortunately, the Virtual Machine I installed on has been wiped away since the issue, so I don't have access to the Tomcat logs. I'm going to set Hudson up later this afternoon on a new machine.
Previous Topic:Deploy Artifacts Checkbox
Next Topic:Debugging Subversion plugin
Goto Forum:
  


Current Time: Thu Aug 21 12:07:04 EDT 2014

Powered by FUDForum. Page generated in 0.03319 seconds