|xdebug.remote_host not resolving host name [message #810025]
||Wed, 29 February 2012 15:33
| Carlos Sanchez
Registered: February 2012
Not sure if this is a XDEBUG or Linux issue but any help is appreciated. The problem is that if I use a host name instead of an IP Address for xdebug.remote_host then address is not resolved and when I attempt to degug a webpage Eclipse stays in the dreaded "Waiting for XDebug session - 57%" state. |
Furthermore, when I use a hostname there is no attempt to access the Eclipse workstation on the XDEBUG port (9000) at all. If I use my Eclipse workstation' IP address, which unfortunately is also dynamic IP address,it all works without glitch.
I want to use a hostname and not an IP address because both server and workstation are remote, have dynamic IP addresses and I am using DynDNS to access them through hostnames. I have no problem accessing the server by itself with the hostname.
If within the server I use "dig" to check the hostname, the IP address gets resolved correctly.
If I use "host" to check the hostname is a different story:
ffmls:~$ host myhost.mydomain.com
Host myhost.mydomain.com not found: 3(NXDOMAIN)
myhost.mydomain.com is just a placeholder in this message for the correct host.domain.com.
I included the DynDNS servers in the resolv.conf file just in case but it makes no difference.
Again, any suggestions are really welcome. Thanks in advance!
Powered by FUDForum
. Page generated in 0.01542 seconds