|[ATL] Copy entire Model without refining mode [message #754413]
||Wed, 02 November 2011 13:39
Registered: November 2011
I am new in ATL and I have the following situation:
I have two models as input (model A and model B - model A uses Profile, that is in a third model file). I want as output a model C that is the same model A with some new elements and new connectors (I will decide wich new elements checking the model B).
First I tried to use the refining mode, but I face some problems, because this mode don`t work fine with two models as input, and I cannot use the "do" statement (I am not sure if I can access stereotypes outside the do statement).
So as second option I decided to clone the entire model (instead use refining mode) and make the changes that I want.
Is it possible?
Thanks in advance.
Powered by FUDForum
. Page generated in 0.06050 seconds