|Create Mindmap wizard won't finish in osx (DSL Toolkit book) [message #583984]
||Thu, 17 September 2009 10:04
| ian mayo
Registered: July 2009
I'm working my way through Richard's DSL Toolkit book.
I've genreated my model, and then generated the editor from it. I've then
run the target application (as instructed on Page 44). I've created a
blank General project, and have requested a new Mindmap Model using the
EMF Model Creation Wizard. I've selected Map as the Model Object, but the
Finish button is still disabled. The page of the wizard is showing a
valid Model Object and XML encoding, but only Back and Cancel are enabled.
Note, this problem doesn't arise running the toolkit under Windows XP.
Powered by FUDForum
. Page generated in 0.05664 seconds