Eclipse Community Forums
Forum Search:

Search      Help    Register    Login    Home
Home » Modeling » Papyrus » How to re-open a diagram?(Newbie question - I guess...)
How to re-open a diagram? [message #556681] Thu, 02 September 2010 10:29 Go to next message
Arto Jarvinen is currently offline Arto JarvinenFriend
Messages: 32
Registered: May 2010
Location: Sweden
Member
I have created a couple of diagrams in Papyrus. I see that the diagram data is in the .notation file (I assume this is the serialization of the model). Then I closed the diagrams using the Close Diagram pop-up command. Now I want to open a diagram again but I can't find any command for that. I'm sure I'm just looking at the wrong place but I've been doing it for quite some time so any hints would be appreciated. Thanks! -Arto


Re: How to re-open a diagram? [message #556702 is a reply to message #556681] Thu, 02 September 2010 11:46 Go to previous messageGo to next message
Tatiana Fesenko is currently offline Tatiana FesenkoFriend
Messages: 21
Registered: May 2010
Junior Member
Hello Arto!

There should be a corresponding .di file next to .notation file. Try to open the *.di file - it should work.

Best wishes,
Tanya.
Re: How to re-open a diagram? [message #556731 is a reply to message #556702] Thu, 02 September 2010 13:18 Go to previous messageGo to next message
Arto Jarvinen is currently offline Arto JarvinenFriend
Messages: 32
Registered: May 2010
Location: Sweden
Member
Thanks Tanya,

I understand. The thing is that if I close all diagram tabs at the bottom of the .di editor and then reopen the editor, its turns up gray, i.e. no diagrams show. That is as it should I guess since i closed the diagrams. But I can't find any way to show the diagram tabs (and thus the associated diagrams) again. I assume that closing a diagram tab doesn't mean that it is deleted? And it seems to remain in the .notation file so the diagram data seems to persist.

Arto


Re: How to re-open a diagram? [message #557006 is a reply to message #556731] Fri, 03 September 2010 15:06 Go to previous message
Yann Tanguy is currently offline Yann TanguyFriend
Messages: 80
Registered: July 2009
Member
Hi,

Expand the model explorer tree to find your diagram, right click on the
diagram in this tree and use "Open" command in the contextual menu.

regards,

YT

Arto Jarvinen a écrit :
> Thanks Tanya,
>
> I understand. The thing is that if I close all diagram tabs at the
> bottom of the .di editor and then reopen the editor, its turns up gray,
> i.e. no diagrams show. That is as it should I guess since i closed the
> diagrams. But I can't find any way to show the diagram tabs (and thus
> the associated diagrams) again. I assume that closing a diagram tab
> doesn't mean that it is deleted? And it seems to remain in the .notation
> file so the diagram data seems to persist.
>
> Arto
Previous Topic:Export to PNG and Problems with class diagrams
Next Topic:How to re-open a diagram?
Goto Forum:
  


Current Time: Fri Dec 19 23:32:36 GMT 2014

Powered by FUDForum. Page generated in 0.03370 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.2.
Copyright ©2001-2010 FUDforum Bulletin Board Software