|info on figure with unknown anchor(s) [message #528081]
||Mon, 19 April 2010 05:18
Registered: July 2009
I need to create a figure with some in / out anchors (similar to the circuit
or led figure in the logic example).
my problem is that I need to create the component after I have read a
configuration file so it could have 1 or 10 input port of one type and 1 or
10 out port of another type ...
what will it be the best way to approach this problem ...
creating, as the circuit, a component and stick sub figure inside ...
as the led example would be nice to create connectors around the shape ...
thanks for any help
Powered by FUDForum
. Page generated in 0.01383 seconds