|attaching eugenia generated diagram with editor [message #513730]
||Wed, 10 February 2010 19:10
| saad bin abid
Registered: October 2009
Hello Epsilon Users,|
I am currently working on a project. I have generated diagram editor using Eugenia. In the run-time environment i am creating both .xxx_diagram and .xxx model. I am evaluating constraints on .xxxx_diagram and can see the markers. but in order to get the same markers on the .xxxx model i have to go to the model and right-click->validate.
Question- Is it possible to make both work side by side? means if markers appear on xxxx_diagram than at the same time it should appear on the .xxxx model as well.
any suggestions please.
thank you very much
Powered by FUDForum
. Page generated in 0.01927 seconds