Home » Modeling » Epsilon » Showing EVL validation in "Problems" view: how to obtain it?
|Re: Showing EVL validation in "Problems" view: how to obtain it? [message #582658 is a reply to message #496284]
||Mon, 09 November 2009 19:23
| Dimitrios Kolovos
Registered: July 2009
I've reproduced this but I'm not really sure how to overcome it. I
suspect the problems view displays markers of workspace resources but
since you're in RCP mode there's no such thing as a workspace.
I'll keep looking for a solution as this will be a good addition to the
EVL/GMF article. If you find any solution before I do, please report
back so that I can add it to the article for the benefit of other people
who may run across the same problem in the future.
Dimitris Kolovos wrote:
> Hi Giovanni,
> OK I see now. I'll have to investigate and get back to you.
> giovanni wrote:
>> The previous question was about how to DISPLAY the 'Problem' view in my
>> Perspective, and it was resolved; now I have the problem on how to MAKE
>> 'Problem' view WORKING: I have the validation enabled and working on
>> diagram surface (with validation markers), but I can't see error and
>> warning messages in my 'Problems' view, that remains blank.
Current Time: Fri Oct 31 04:07:35 GMT 2014
Powered by FUDForum
. Page generated in 0.02287 seconds