|Eclipse + JBoss Debug Mode issue [message #213863]
||Wed, 14 May 2008 12:53
Originally posted by: nameghino.coto.com.ar|
I'm having an issue regarding a debug deployment using Eclipse + JBoss
Whenever I deploy my application in debug mode, it takes a big load of
time to deploy it (around 20-30 minutes). However, sometimes it deploys in
2 minutes (in debug mode) and it just takes 1.5 minutes in run mode.
This behavior is mostly random, but after the first occurrence of the
long-time debug deployment, it's mostly sure that it will happen again.
Note that I've already posted this in the eclipse.newcomers group and
Wayne Beaton suggested that I should post this issue here and in a JBoss
I have a "virgin environment" (all I did to it was configure it to work
and then never touched it again) so that I can spawn the same installation
in several computers and have the same contents everywhere in another PC
with Eclipse 3.3.2 (Build M20080221-1800) and JBoss 4.2.2GA which I
compared against my installation of the bundle.
It turned out that two files were changed between those two installations:
I tried overwriting those two files with the virgin copies, but without
result. I then deleted my whole eclipse folder and downloaded the virgin
environment. Still no good.
Some time later, I proceeded to undeploy the application from the server,
delete the temp files from it, do a full clean build of the app. and then
redeployed. It worked for a couple of debug deployments but now the
problem is back. I repeated those steps, hoping it would work, but
unfortunately it didn't.
Finally, I also noted that, if given the 20-30 minutes' time it requires
to deploy the application in debug mode, the application is a lot slower
than the usual debug deployments that take 2 minutes.
Any help appreciated, and thanks!