Eclipse Community Forums: Eclipse 4 » How to tell and convert to pure e4

Help

Home

Home » Eclipse Projects » Eclipse 4 » How to tell and convert to pure e4

Show: Today's Messages :: Show Polls :: Message Navigator

How to tell and convert to pure e4 [message #987171]

Fri, 23 November 2012 19:55

Mike Shreek
Messages: 16
Registered: September 2012

Junior Member

Hi, I started developing my application in E4 RCP. But since I was on my learning curve(First time to write an eclipse application). I might accidentally converted my application into "Not so pure" e4 application. Thus, resulting into compatibility mode which I suspected because alot of bugs that I have been encountering was because of compatibility mode.

So my question is how to convert my application back to PURE E4 Application.

PS: I am a newbie in eclipse so if you could be more detailed... Thank you!

Report message to a moderator

[Message index]

		How to tell and convert to pure e4 By: Mike Shreek on Fri, 23 November 2012 19:55
		Re: How to tell and convert to pure e4 By: Sopot Cela on Sun, 25 November 2012 12:17
		Re: How to tell and convert to pure e4 By: Lars Vogel on Tue, 27 November 2012 12:59
		Re: How to tell and convert to pure e4 By: Mike Shreek on Tue, 27 November 2012 20:16
		Re: How to tell and convert to pure e4 By: Lars Vogel on Wed, 28 November 2012 01:33

Previous Topic:	Stop part from closing?
Next Topic:	How to create a handler by id?

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

]

Current Time: Tue May 21 20:08:53 EDT 2013