Eclipse Community Forums: M2T (model-to-text transformation)

Help

Home

Home » Modeling » M2T (model-to-text transformation) » Invoking JET2 from within code

Show: Today's Messages :: Show Polls :: Message Navigator

Invoking JET2 from within code [message #11454]

Thu, 12 April 2007 10:42

Eclipse User

Originally posted by: evaandoli.dodo.com.au

Hi,
This sounds simple but I can't find any pointers.
I have created a GMF diagram and fired off an action to call my Jet
transformation.
What code do I use to start off Jet.
So far I have always used JET2 using the RUN option setup but never from
code.

Any pointers would be good thanks,
Stu

Report message to a moderator

[Message index]

		Invoking JET2 from within code By: Eclipse User on Thu, 12 April 2007 10:42
		Re: Invoking JET2 from within code By: Eclipse User on Fri, 13 April 2007 08:22
		Re: Invoking JET2 from within code By: Paul Elder on Fri, 13 April 2007 08:24
		Re: Invoking JET2 from within code By: Eclipse User on Fri, 13 April 2007 09:07
		Re: Invoking JET2 from within code By: Eclipse User on Tue, 17 April 2007 01:07
		Re: Invoking JET2 from within code By: Paul Elder on Wed, 18 April 2007 09:14

Previous Topic:	Jet directive not found
Next Topic:	Could not load JET template loader

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

]

Current Time: Fri May 24 03:34:40 EDT 2013