|Launch Failed. Binary Not Found. But found after refresh [message #881180]
||Mon, 04 June 2012 00:11
| Karthikeyan Missing name
Registered: September 2011
I am running Eclipse Juno in Fedora 17 with CDT plugin. I was trying to run a sample application. I tried to build the application. The console said:
**** Build of configuration Debug for project HelloWorld ****
Building file: ../main.c
Invoking: GCC C Compiler
gcc -O0 -g3 -Wall -c -fmessage-length=0 -MMD -MP -MF"main.d" -MT"main.d" -o "main.o" "../main.c"
../main.c: In function 'main':
../main.c:10:2: warning: implicit declaration of function 'printf' [-Wimplicit-function-declaration]
../main.c:10:2: warning: incompatible implicit declaration of built-in function 'printf' [enabled by default]
Finished building: ../main.c
Building target: HelloWorld
Invoking: GCC C Linker
gcc -o "HelloWorld" ./main.o
Finished building target: HelloWorld
**** Build Finished ****
The project explorer showed the Debug folder, but the executable was not shown.(see screenshot Step:1-After Build). But in the actual filesystem location (in nautilus) the executable is present. While I try to run using (right click -> Run As -> Local C/C++ application, the launcher give the error, Launch Failed. Binary Not Found (Screenshot: Step:2-Launch Failed_Binary NotFound). Then I did a refresh on the project explorer (right click -> Refresh F5), the executalbes were visible (Screenshot: Step:3-Refreshed). Now I ran the project as mentioned earlier and it ran successfully (Screenshot: Step:4-RanSuccessfull). I have to do a refresh every time I do a compile. I am not sure why this is happening.
This did not used to happen in the earlier versions of eclipse (Indigo and Helios). Could you help me, so that I dont have to do this refresh every time.
Powered by FUDForum
. Page generated in 0.01399 seconds